Traduction de «Dispositif d'orientation des tuyères » (Français → Anglais) :

(2) A forward-facing child restraint system is not required to conform to the requirements of paragraphs 215(1)(e) and (f) if the target point located on either side of the head of the heaviest of the anthropomorphic test devices used in the dynamic test — other than an anthropomorphic test device specified in subpart I, N or S, part 572, chapter V, title 49 of the Code of Federal Regulations of the United States (revised as of October 1, 2012) — and located on the transverse axis passing through the centre of mass of the device’s head and perpendicular to the head’s midsagittal plane is below a horizontal plane tangent to the top of the ...[+++] standard seat assembly when the anthropomorphic test device is positioned in the restraint system in accordance with subsection 4.4.2 or 4.5.2 of Test Method 213 and the restraint system is installed on the standard seat assembly in accordance with subsection 4.4.1 or 4.5.1 of Test Method 213.

In order to avoid omissions and mistakes in the verification by the notified bodies of the important aspects of clinical evaluation or, in the case of in vitro diagnostic medical devices, of performance evaluation, and with regard to the post-market clinical follow-up, or, in the case of in vitro diagnostic medical devices, to post-market follow up, it is important to provide specific advice with regard to the control of those requirements.

To facilitate the verification by the notified bodies of the technical documentation, the manufacturer’s device identification system and the declaration of conformity, it is important to provide specific advice with regard to the control of those requirements.

These tests include low-noise fans, novel intake liners, bypass and hot-stream liners, nozzle jet noise suppressers, active control techniques and airframe noise reduction technologies.

the guidelines contained in the multi-annual guidance programmes (MGP IV until 2001 and MGP V thereafter) as the basic frame of reference.

Under the common position, the aim of the common framework of objectives is to contribute to the achievement of the objectives of Article 127 of the Treaty by pursuing a number of objectives such as: - improving the quality and innovation capacity of Member States' vocational training systems and arrangements; - developing the European dimension in vocational training and vocational guidance; - promoting lifelong training so as to encourage the ongoing adaptation of skills to meet the needs of workers and undertakings, contribute to ...[+++] reducing unemployment and facilitate personal development; - giving all young people in the Community who so wish the possibility of one or, if possible, two or more years of initial vocational training after their full-time compulsory education, leading to a vocational qualification recognized by the competent authorities of the Member State in which it is obtained; - encouraging specific vocational training measures for adults without adequate vocational qualifications, in particular adults without adequate education; - supporting vocational policies in such a way that all workers in the Community have access to continuing vocational training throughout their working life without any discrimination; - promoting equality of opportunity as regards access for men and women to vocational training and their effective participation therein, in particular so as to open up new areas of work to them and to encourage them to return to work after a career break; - supporting activities aimed at developing linguistic skills as part of vocational training measures; - promoting the development of vocational guidance facilities in order to guarantee life-long high-quality vocational guidance for all.