Traduction de «Essai conforme aux normes de l'APHA » (Français → Anglais) :

(2) A person who conducts a test under subsection (1) does not contravene these Regulations if the mobile PCB destruction system or mobile PCB treatment system does not meet the standards set out in sections 5 to 9 during the test.

They test and certify to a Canadian standard, not to an American standard or a Japanese standard.

as the most valuable toxicity information, actual test data from in vivo or in vitro studies obtained in accordance with Commission Regulation (EC) No 440/2008 of 30 May 2008 laying down test methods pursuant to Regulation (EC) No 1907/2006 of the European Parliament and of the Council on the Registration, Evaluation, Authorisation and Restriction of Chemicals (REACH) (22), recognised international guidelines, or standards (e.g. OECD Test Guidelines), and performed in accordance with good laboratory practice principles;

All tests referred to in Articles 3 and 4 and in Annexes II, III, IV and VIII shall be conducted in compliance with the standards mentioned in Annex I. 1 and in accordance with testing requirements under Article 10(5) of Regulation (EEC) No 793/93.

1.2. For all stage 2 engines, if, when properly tested according to the procedures in this Directive, all test engines representing an engine family have emissions which, when adjusted by multiplication by the deterioration factor (DF) laid down in this Appendix, are less than or equal to each stage 2 emission standard (family emission limit (FEL), where applicable) for a given engine class, that family shall be considered to comply with the emission standards for that engine class.

Whereas, therefore, this Directive sets out essential requirements only; whereas, in order to facilitate the task of proving compliance with the essential requirements, harmonized European standards are necessary, more especially with regard to the non-electrical aspects of protection against explosions - standards relating to the design, manufacture and testing of equipment, compliance with which enables a product to be presumed to meet such essential requirements; whereas harmonized European standards are drawn up by private bodies and must retain their non-mandatory status; whereas, for this purpose, the European Committee for Stan ...[+++]dardization (CEN) and the European Committee for Electrotechnical Standardization (Cenelec) are recognized as the bodies competent to adopt harmonized standards which follow the general guidelines for cooperation between the Commission and those two bodies, signed on 13 November 1984; whereas, for the purposes of this Directive, a harmonized standard is a technical specification (European Standard or harmonization document) adopted by one or other of those bodies, or by both, at the prompting of the Commission pursuant to Council Directive 83/189/EEC of the 28 March 1983 providing for a procedure governing the provision of information on technical standards and regulations (1) and pursuant to the general guidelines referred to above;