Traduction de «Initial temperature » (Anglais → Français) :

initial heat [ striking heat | initial temperature ]

initial freezing temperature | temperature of initial ice formation

temperature of incident melting [ initial fusion temperature ]

initial fusion temperature

A rare mitochondrial disease due to a defect in mitochondrial protein synthesis with a variable phenotype that includes onset in infancy or early childhood of failure to thrive and psychomotor regression (after initial normal development), as well as

Chancre of yaws Framboesia, initial or primary Initial framboesial ulcer Mother yaw

A group of tyrosine related oculocutaneous albinism (OCA1) that includes OCA1A, OCA1B, type 1 minimal pigment oculocutaneous albinism (OCA1-MP) and type 1 temperature sensitive oculocutaneous albinism (OCA1-TS). The phenotypic spectrum seen in OCA1 i

A rare non-dystrophic myopathy with characteristics of slowly progressive muscular weakness and atrophy initially involving proximal lower limbs and hip girdle and later on shoulder girdle, proximal upper limbs and axial muscles. Ambulation is usuall

crushed to pieces of approximately 15 mm and degreased with hot water at a temperature of minimum 70 °C for at least 30 minutes, minimum 80 C for at least 15 minutes, or minimum 90 °C for at least 10 minutes, and then separated and subsequently washed and dried for at least 20 minutes in a stream of hot air with an initial temperature of minimum 350 °C, or for 15 minutes in a stream of hot air with an initial temperature of more than 700 °C,

Frozen fishery products must be kept at a temperature of not more than – 18 °C in all parts of the product; however, whole fish initially frozen in brine intended for the manufacture of canned food may be kept at a temperature of not more than – 9 °C’.

An initial temperature mapping exercise should be carried out on the storage area before use, under representative conditions.

41 (1) Every “A” Class division shall be constructed of steel or similar material, in either case stiffened so as to be capable of preventing the passage of smoke and flame throughout a standard fire test of 60 minutes duration; the division shall have an adequate insulating value having regard to the nature of the spaces adjacent thereto, and if the division is between spaces either of which contains adjacent combustible material, it shall be so insulated that, if either face of the division is exposed to a standard fire test of 60 minutes duration, the average temperature on the unexposed face of the division will not increase at any time during the test by more than 139°C above the initial temperature ...[+++] on that face nor shall the temperature at any one point thereon increase by more than 180°C above the initial temperature.