Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Angle of deflection
Angle of deviation
Beam deflection
Beam deflection angle
Beam deflection tube
Beam-deflection tube
Deflection angle
Deflection angle of a motivator component
Electron-beam deflection system
Nosewheel angle
Nosewheel deflection angle
Nosewheel steering angle
Steering angle

Traduction de «beam deflection angle » (Anglais → Français) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous


deflection angle | angle of deflection

angle de déviation


deflection angle of a motivator component [ deflection angle ]

angle de braquage d'un élément de gouverne [ angle de braquage ]


nosewheel steering angle [ nosewheel deflection angle | nosewheel angle | steering angle ]

angle de braquage de la roue avant


angle of deviation | deflection angle

angle de déflexion | angle de déviation


electron-beam deflection system

dispositif de déflexion






TRADUCTIONS EN CONTEXTE
The lashings shall be tightened so that there is a deflection in the tyre adjacent to the lashing as indicated in point 3.1.5 of Annex II. After lashing, a wooden beam shall be placed as a prop against the wheel opposite the weight and secured to the floor so that it is held tightly against the wheel rim during impact as shown in Annex IV, fig. 7. The length of the beam shall be chosen so that when in position against the wheel it is at an angle of 30 ± 3 ...[+++]

Les câbles sont tendus pour donner une déflection du pneu adjacent au câble correspondant aux indications de l’annexe II, point 3.1.5. Après le raidissement des câbles, une pièce de bois est placée comme cale contre la roue à l’opposé du poids et bloquée au sol de manière à être fermement maintenue contre la jante de la roue pendant le choc, suivant l’annexe IV, figure 7. La longueur de la poutre est choisie de façon que, placée contre la roue, elle soit à un angle de 30° ± 3 par rapport à l’horizontale.


Annex II A.With the wire ropes tensioned, the wedging beam shall be placed firmly behind the rear wheels and then fixed to the ground.1.2.3.If the tractor is of the articulated type, the point of articulation shall in addition be supported by a wooden block at least 100 mm square and firmly lashed to the ground.1.2.4.The pendulum block shall be pulled back so that the height of its centre of gravity above that at the point of impact is given by one of the following two formulae, to be chosen according to the reference mass of the tractors subjected to the tests:H = 25 + 0,07 mt for tractors with a reference mass of less than 2 000 kilogr ...[+++]

le bord supérieur. La position du centre de gravité du mouton se situe à un sixième de la largeur du sommet du dispositif de protection à l'intérieur d'un plan vertical parallèle au plan médian du tracteur touchant l'extrémité supérieure du sommet de dispositif de protection.Si le dispositif est courbe ou saillant en ce point, des coins doivent être ajoutés pour que le choc ait lieu en ce point, sans que cela se traduise par un renforcement du dispositif.1.2.2.Le tracteur doit être ancré au sol au moyen de quatre câbles, disposés chacun à une extrémité des deux essieux, conformément aux indications de la figure 6 de l'annexe IV. Les poi ...[+++]


The lashings shall be tightened so that there is a deflection in the tyre adjacent to the lashing as indicated in 3.1.5 of Annex II. After lashing, a wooden beam shall be placed as a prop against the wheel opposite the weight and secured to the floor so that it is held tightly against the wheel rim during impact as shown in Annex IV, fig. 7. The length of the beam shall be chosen so that when in position against the wheel it is at an angle of 30 ± 3º to the h ...[+++]

Les câbles sont tendus pour donner une déflection du pneu adjacent au câble correspondant aux indications de l'annexe II point 3.1.5. Après le raidissement des câbles, une pièce de bois est placée comme cale contre la roue à l'opposé du poids et bloquée au sol de manière à être fermement maintenue contre la jante de la roue pendant le choc, suivant l'annexe IV figure 7. La longueur de la poutre est choisie de façon que, placée contre la roue, elle soit à un angle de 30º ± 3 par rapport à l'horizontale.




datacenter (1): www.wordscope.fr (v4.0.br)

'beam deflection angle' ->

Date index: 2023-10-07
w