Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Bend
Bottom-end
Bottom-of-the-line
Bottom-of-the-range
Caulk the tube ends
Down market
Down-market
End of bend
End of the bend
End of the curve
End of the turn
Entry level
Front end of the fuel cycle
Front-end of the fuel cycle
Hammer the tube ends
Join end to end
Low-end
Low-range
Lower end of the range
Lower-ended
Provide end-of-life care
Support service users at end of life
Support service users at the end of life
Support social service users at the end of life
To tighten the tube ends
Union-end return bend

Traduction de «end the bend » (Anglais → Français) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous




end of the bend [ end of the curve | end of the turn ]

sortie de virage [ fin du virage ]




end cutting nipper for distance cutting and for bending the wire to an angle alpha degree

pince coupante en bout et à distance, pliant le fil à l'angle degré alpha


provide end-of-life care | support service users at the end of life | support service users at end of life | support social service users at the end of life

soutenir les usagers des services sociaux en fin de vie


caulk the tube ends | hammer the tube ends | to tighten the tube ends

mater les extrémités des tubes


Open-Ended Working Group of the Parties to the Montreal Protocol | Open-Ended Working Group of the Parties to the Montreal Protocol on Substances that Deplete the Ozone Layer

groupe de travail à composition non limitée des Parties au Protocole de Montréal relatif à des substances qui appauvrissent la couche d'ozone


down market | down-market | lower end of the range | low-end | low-range | lower-ended | bottom-of-the-line | bottom-of-the-range | bottom-end | entry level

bas de gamme | entrée de gamme


front-end of the fuel cycle | front end of the fuel cycle

partie initiale du cycle du combustible
TRADUCTIONS EN CONTEXTE
(6) The lower end of the vent pipe on all storage tanks shall not extend more than one inch through the top of the storage tank and shall be installed so that the pipe will drain into the storage tank without traps or bends in which liquid can collect.

(6) L’extrémité inférieure des tuyaux d’évent sur tous les réservoirs d’emmagasinage pénétrera par le dessus du réservoir et ne s’avancera pas de plus de un pouce; le tuyau sera installé de façon à assurer l’écoulement dans le réservoir et il ne présentera ni siphons ni coudes où le liquide pourrait s’accumuler.


especially designed or prepared tubes of up to 12 mm (0.5 in) internal diameter for the extraction of UF gas from within the rotor tube by a Pitot tube action (that is, with an aperture facing into the circumferential gas flow within the rotor tube, for example by bending the end of a radially disposed tube) and capable of being fixed to the central gas extraction system.

tubes ayant un diamètre interne d’au plus 12 mm (0,5 po), spécialement conçus ou préparés pour extraire l’UF gazeux contenu dans le bol selon le principe du tube de Pitot (c’est-à-dire que leur ouverture débouche dans le flux gazeux périphérique à l’intérieur du bol, configuration obtenue par exemple en courbant l’extrémité d’un tube disposé selon le rayon) et pouvant être raccordés au système central de prélèvement du gaz.


(6) The lower end of the vent pipe on all storage tanks shall not extend more than one inch through the top of the storage tank and shall be installed so that the pipe will drain into the storage tank without traps or bends in which liquid can collect.

(6) L’extrémité inférieure des tuyaux d’évent sur tous les réservoirs d’emmagasinage pénétrera par le dessus du réservoir et ne s’avancera pas de plus de un pouce; le tuyau sera installé de façon à assurer l’écoulement dans le réservoir et il ne présentera ni siphons ni coudes où le liquide pourrait s’accumuler.


Every measure coming up to the Senate from the House would be subject to tweakings and bendings, large and small, and what we would have in the end is a conveyor belt of money in favour of the less productive provinces over the more productive and populous ones.

Et toutes les mesures soumises au Sénat par la Chambre feraient l'objet de tractations et de magouillages de tous calibres, pour aboutir à une courroie de transmission d'argent des provinces plus productives et plus populeuses vers les provinces moins productives.


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
Yes, there should be an opposition but when that opposition goes to the custom election code and bends it in their favour, the elected chief ends up in court.

Il faut qu'il y ait une opposition, je suis d'accord, mais quand cette opposition utilise le code électoral coutumier pour favoriser ses propres intérêts, le chef élu se retrouve devant les tribunaux.


The maximum dynamic knee bending angle shall not exceed 24,0 °, the maximum dynamic knee shearing displacement shall not exceed 7,5 mm, and the acceleration measured at the upper end of the tibia shall not exceed 215 g.

L’angle maximal de flexion dynamique du genou ne dépasse pas 24,0°, le déplacement dynamique maximal en cisaillement du genou ne dépasse pas 7,5 mm et l’accélération mesurée à l’extrémité supérieure du tibia ne dépasse pas 215 g.


For an FPS approved for fitting to vehicles that comply with the requirements of Section 3 the maximum dynamic knee bending angle shall not exceed 19,0 °, the maximum dynamic knee shearing displacement shall not exceed 6,0 mm, and the acceleration measured at the upper end of the tibia shall not exceed 170 g.

Pour un système de protection frontale réceptionné en vue de l’équipement de véhicules qui répondent aux exigences de la section 3, l’angle maximal de flexion dynamique du genou ne dépasse pas 19,0°, le déplacement dynamique maximal en cisaillement du genou ne dépasse pas 6,0 mm et l’accélération mesurée à l’extrémité supérieure du tibia ne dépasse pas 170 g.


The maximum dynamic knee bending angle shall not exceed 19,0 °, the maximum dynamic knee shearing displacement shall not exceed 6,0 mm, and the acceleration measured at the upper end of the tibia shall not exceed 170 g.

L’angle maximal de flexion dynamique du genou ne dépasse pas 19,0°, le déplacement dynamique maximal en cisaillement du genou ne dépasse pas 6,0 mm et l’accélération mesurée à l’extrémité supérieure du tibia ne dépasse pas 170 g.


For an FPS approved for fitting to vehicles that comply with the requirements of Section 2 the maximum dynamic knee bending angle shall not exceed 21,0 °, the maximum dynamic knee shearing displacement shall not exceed 6,0 mm, and the acceleration measured at the upper end of the tibia shall not exceed 200 g.

Pour un système de protection frontale réceptionné en vue de l’équipement de véhicules qui répondent aux exigences de la section 2, l’angle maximal de flexion dynamique du genou ne dépasse pas 21,0°, le déplacement dynamique maximal en cisaillement du genou ne dépasse pas 6,0 mm et l’accélération mesurée à l’extrémité supérieure du tibia ne dépasse pas 200 g.


The maximum dynamic knee bending angle shall not exceed 21,0 °, the maximum dynamic knee shearing displacement shall not exceed 6,0 mm, and the acceleration measured at the upper end of the tibia shall not exceed 200 g;

L’angle maximal de flexion dynamique du genou ne dépasse pas 21,0°, le déplacement dynamique maximal en cisaillement du genou ne dépasse pas 6,0 mm et l’accélération mesurée à l’extrémité supérieure du tibia ne dépasse pas 200 g;




datacenter (1): www.wordscope.fr (v4.0.br)

'end the bend' ->

Date index: 2024-05-12
w