Traduction de «machine tending » (Anglais → Français) :

notching machines operating | tending notching machines | notching machines tending | tend notching machines

asphalt mixing machine tending | tending asphalt mixing machine | operate asphalt mixing machine | tend asphalt mixing machine

repair automatic sewing machines | tending automatic sewing machines | tend automatic sewing machine | tend automatic sewing machines

A rare hereditary motor and sensory neuropathy disorder with characteristics of the typical CMT phenotype (slowly progressive distal muscle atrophy and weakness in upper and lower limbs, distal sensory loss in extremities, reduced or absent deep tend

A rare acquired dermis elastic tissue disorder with characteristics of a pseudoxanthoma elasticum-like papular eruption consisting of multiple, slowly progressive, asymptomatic, 2-5 mm, white to yellowish, non-follicular papules (that tend to form co

Definition: An ill-defined disorder of uncertain nosological validity. The category is designed to include a group of children with severe mental retardation (IQ below 35) who show major problems in hyperactivity and in attention, as well as stereotyped behaviours. They tend not to benefit from stimulant drugs (unlike those with an IQ in the normal range) and may exhibit a severe dysphoric reaction (sometimes with psychomotor retardation) when given stimulants. In adolescence, the overactivity tends to be replaced by underactivity (a pattern that is not usual in hyperkinetic children with normal intelligence). This syndrome is also often ...[+++] associated with a variety of developmental delays, either specific or global. The extent to which the behavioural pattern is a function of low IQ or of organic brain damage is not known.

A rare acquired idiopathic dermal tissue disorder characterized by numerous asymptomatic 2-3 millimeter yellowish, non-follicular papules that tend to converge into cobblestone-like plaques. The plaques are distributed symmetrically over the posterio

We tend not to have those capacities in architecture faculties. However, we do have high-tech cutting machines and forming machines that allow us to experiment, mostly at a small scale.

4.9.1. If the 3-D H machine tends to slide rearward, use the following procedure. Allow the 3-D H machine to slide rearward until a forward horizontal restraining load on the T-bar is no longer required i.e. until the seat pan contacts the seat-back.

4.9.2. If the 3-D H machine does not tend to slide rearward, use the following procedure. Slide the 3-D H machine rearwards by applying a horizontal rearward load to the T-bar until the seat pan contacts the seat-back (see Figure 2 of Appendix 1 to this Annex).

During the rocking action, the T-bar of the 3-D H machine may tend to diverge from the specified horizontal and vertical alignment.