Traduction de «tolerance factor » (Anglais → Français) :

Definition: This block contains a wide variety of disorders that differ in severity and clinical form but that are all attributable to the use of one or more psychoactive substances, which may or may not have been medically prescribed. The third character of the code identifies the substance involved, and the fourth character specifies the clinical state. The codes should be used, as required, for each substance specified, but it should be noted that not all fourth character codes are applicable to all substances. Identification of the psychoactive substance should be based on as many sources of information as possible. These include self-report data, analysis of blood and other body fluids, characteristic physical and psychological symptom ...[+++]s, clinical signs and behaviour, and other evidence such as a drug being in the patient's possession or reports from informed third parties. Many drug users take more than one type of psychoactive substance. The main diagnosis should be classified, whenever possible, according to the substance or class of substances that has caused or contributed most to the presenting clinical syndrome. Other diagnoses should be coded when other psychoactive substances have been taken in intoxicating amounts (common fourth character .0) or to the extent of causing harm (common fourth character .1), dependence (common fourth character .2) or other disorders (common fourth character .3-.9). Only in cases in which patterns of psychoactive substance-taking are chaotic and indiscriminate, or in which the contributions of different psychoactive substances are inextricably mixed, should the diagnosis of disorders resulting from multiple drug use (F19.-) be used. | Modifiers The following fourth-character subdivisions are for use with categories F10-F19: Code Title .0 Acute intoxication A condition that follows the administration of a psychoactive substance resulting in disturbances in level of consciousness, cognition, perception, affect or behaviour, o ...

aligning tolerances | tolerance aligning | set tolerances | tolerances setting

Definition: Personality disorder characterized by disregard for social obligations, and callous unconcern for the feelings of others. There is gross disparity between behaviour and the prevailing social norms. Behaviour is not readily modifiable by adverse experience, including punishment. There is a low tolerance to frustration and a low threshold for discharge of aggression, including violence; there is a tendency to blame others, or to offer plausible rationalizations for the behaviour bringing the patient into conflict with society. | Personality (disorder):amoral | antisocial | asocial | psychopathic | sociopathic

Definition: A syndrome that occurs following head trauma (usually sufficiently severe to result in loss of consciousness) and includes a number of disparate symptoms such as headache, dizziness, fatigue, irritability, difficulty in concentration and performing mental tasks, impairment of memory, insomnia, and reduced tolerance to stress, emotional excitement, or alcohol. | Postcontusional syndrome (encephalopathy) Post-traumatic brain syndrome, nonpsychotic

A new factor influencing the use of PPPs is the cultivation of genetically modified herbicide tolerant and pest tolerant plants (GMO).

However, Member States also create pull factors by tolerating the illegal employment of third-country nationals.

J. whereas, on the basis of an analysis by the Joint Research Centre (JRC), the Commission has concluded the current average PEMS error of measurement to be 18.75 %, corresponding to a maximum compliance factor of 1.2; whereas the JRC error analysis concluded that the RDE testing procedure may introduce a measurement uncertainty margin of up to maximum 30 %, i.e. a ‘worst case margin’ of 25 mg NOx/km for the Euro 6 limit, equivalent to a compliance factor of 1.3; whereas such tolerances or initial uncertainties of the emissions meas ...[+++]urement procedure are expected to become smaller over time thanks to technical progress;

9. Urges the Council and the Commission, accordingly, to come to an early agreement on a framework for a Real Driving Emissions (RDE) test on that basis and swift adoption of the procedure in comitology following agreement on the legislative proposal; underlines that secondary legislation in this area must be diligently prepared and must provide clarity for national authorities and manufacturers in sufficient time to facilitate compliance with such requirements upon their entry into force; considers it essential that any conformity factor applied as an interim measure is limited, and that the reasons for its application and the list of models benefiting ...[+++]from such tolerances are clearly and prominently explained to consumers; believes that consumers are not well served by legislation which purports to establish standards, but which in its application allows a different level of compliance; furthermore, expresses concern about legal certainty where conformity factors permit different levels of compliance between products;