Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Forme à tableau vertical arrière immergé

Traduction de «Forme à tableau vertical arrière immergé » (Français → Anglais) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous
forme à tableau vertical arrière immergé

transom stern


forme à tableau vertical arrière immergé

transom stern
TRADUCTIONS EN CONTEXTE
Par «siège faisant face vers l'arrière», un siège qui peut être utilisé lorsque le véhicule est en mouvement et qui est orienté vers l'arrière du véhicule, de manière que le plan vertical de symétrie du siège forme avec le plan vertical de symétrie du véhicule, un angle inférieur à + 10° ou – 10°;

‘Rearward-facing seat’ means a seat which can be used while the vehicle is in motion and which faces towards the rear of the vehicle in such a manner that the vertical plane of symmetry of the seat forms an angle of less than + 10° or – 10° with the vertical plane of symmetry of the vehicle;


2. Les mentions visées à l'article 29, paragraphes 1 et 2, sont présentées sur la face arrière de l'emballage sous forme de tableau, si la place le permet, avec alignement des chiffres.

2. The particulars referred to in Article 29(1) and (2) shall be presented on the back of pack in tabular format, if space permits, with the numbers aligned.


Siège orienté vers l'arrière": un siège pouvant être utilisé lorsque le véhicule est en mouvement et qui est orienté vers l'arrière du véhicule de manière à ce que le plan vertical de symétrie du siège forme un angle inférieur à +10º ou –10º par rapport au plan vertical de symétrie du véhicule;

Rearward-facing seat" means a seat which can be used whilst the vehicle is in motion and which faces towards the rear of the vehicle in such a manner that the vertical plane of symmetry of the seat forms an angle of less than +10o or -10o with the vertical plane of symmetry of the vehicle;


A. Essais dynamiques 1.ESSAIS DE CHOC ET D'ÉCRASEMENT 1.1.Choc à l'arrière 1.1.1.La position du tracteur par rapport au mouton pendule doit étre telle que ce dernier heurte le dispositif de protection au moment où sa face d'impact ainsi que ses chaînes ou câbles de suspension forment avec le plan vertical un angle égal à 100mt avec un maximum de 20°, à moins que le dispositif de protection au point de contact ne forme, pendant la déformation, un angle supérieur par rapport à la vertical ...[+++]

A. Dynamic tests 1.IMPACT AND CRUSHING TESTS 1.1.Impact at the rear 1.1.1.The tractor must be so placed in relation to the pendulum block that the block will strike the protection structure when the impact face of the block and the supporting chains or wire ropes are at an angle with the vertical plane equal to mt/100 with a 20° maximum, unless, during deflection, the protection structure at the point of contact forms a greater angle to the vertical.


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
le bord supérieur. La position du centre de gravité du mouton se situe à un sixième de la largeur du sommet du dispositif de protection à l'intérieur d'un plan vertical parallèle au plan médian du tracteur touchant l'extrémité supérieure du sommet de dispositif de protection.Si le dispositif est courbe ou saillant en ce point, des coins doivent être ajoutés pour que le choc ait lieu en ce point, sans que cela se traduise par un renforcement du dispositif.1.2.2.Le tracteur doit être ancré au sol au moyen de quatre câbles, disposés chacun à une extrémité des deux essieux, conformément aux indications de la figure 6 de l'annexe IV. Les points d'ancrage ...[+++]

Annex II A.With the wire ropes tensioned, the wedging beam shall be placed firmly behind the rear wheels and then fixed to the ground.1.2.3.If the tractor is of the articulated type, the point of articulation shall in addition be supported by a wooden block at least 100 mm square and firmly lashed to the ground.1.2.4.The pendulum block shall be pulled back so that the height of its centre of gravity above that at the point of impact is given by one of the following two formulae, to be chosen according to the reference mass of the tractors subjected to the tests:H = 25 + 0,07 mt for tractors with a reference mass of less than 2 000 kilograms,H = 125 + 0,02 mt for tractors with a reference mass of more than 2 000 kilograms.The pendulum block ...[+++]




D'autres ont cherché : Forme à tableau vertical arrière immergé     


datacenter (12): www.wordscope.fr (v4.0.br)

Forme à tableau vertical arrière immergé ->

Date index: 2021-05-15
w