Traduction de «Soupape de coupure du carburant » (Français → Anglais) :

The fuel container type (i.e. LPG liquid take off/vapour pressure, LPG vapour take off, LPG liquid take off/pressurised by pump, pressurised CNG take off), the safety devices and fuel container accessories, as required by Regulation No 67, 01 series of amendments, or Regulation No 110, where applicable (i.e. relief valve);

‘safety accessories’ means devices designed to protect pressure equipment against the allowable limits being exceeded, including devices for direct pressure limitation, such as safety valves, bursting disc safety devices, buckling rods, controlled safety pressure relief systems (CSPRS), and limiting devices, which either activate the means for correction or provide for shutdown or shutdown and lockout, such as pressure switches or temperature switches or fluid level switches and safety related measurement control and regulation (SRMCR) devices;

The overall socio-economic situation in the country is rapidly deteriorating: shortages in fuel, cooking gas and drinking water as well as electricity cuts are a growing concern.

4.3.1. Non-emission-related scheduled maintenance which is reasonable and technically necessary (e.g. oil change, oil filter change, fuel filter change, air filter change, cooling system maintenance, idle speed adjustment, governor, engine bolt torque, valve lash, injector lash, timing, adjustment of the tension of any drive-belt, etc) may be performed on engines or vehicles selected for the service accumulation schedule at the least frequent intervals recommended by the manufacturer to the owner (e.g. not at the intervals recommended for severe service).

d. One or more other components (including exhaust ports, turbochargers, valve guides, valve assemblies or insulated fuel injectors);

2. From 1 October 1990, Member States may prohibit the entry into service of vehicles fitted with a positive ignition engine whose fuel requirements do not meet the provisions of the Annexes to Directive 70/220/EEC, as amended by this Directive, except where the manufacturer provides a certificate accepted by the technical service which issued the initial emission type-approval stating that adapting such vehicles to the new fuel requirement entails major engineering changes, namely a change in material specification of the inlet or exhaust valve seats or a reduction in the compression ratio, or an increase in the engine capacity to compe ...[+++]nsate for power loss ; in which case, such a ban is possible only from the dates laid down in Article 2 (3).