Traduction de «arceau de fixation de bâche » (Français → Anglais) :

tarpaulin bow | top bow | roof bow | tarp bow

tarpaulin holddown strap

Direct securing with nets and blankets

ANNEX TO THE EEC TYPE-APPROVAL CERTIFICATE FOR A TRACTOR TYPE WITH REGARD TO THE STRENGTH OF PROTECTION STRUCTURES (REAR-MOUNTED ROLLBAR, FRAME OR CAB) AND THE STRENGTH OF THEIR ATTACHMENT TO THE TRACTOR(Articles 4 (2) and 10 of Council Directive 74/150/EEC of 4 March 1974 on the approximation of the laws of the Member States relating to the type-approval of wheeled agricultural or forestry tractors)EEC type-approval No: extension (; ) 1.Trade name or mark of tractor: 2.Tractor type and commercial description: 3.Name and address of tractor manufacturer: 4.If applicable, name and address of manufacturer's authorized representative: 5.Trad ...[+++]e name or mark and type of protection structure: 6.Extension of EEC-approval for the following type(s) of protection structure: 7.Tractor submitted for EEC type-approval on: 8.Technical service responsible for EEC type-approval conformity control: 9.Date of report issued by that service: 10.Number of report issued by that service: 11.EEC type-approval with regard to the strength of the protection structures and the strength of their attachment to the tractor has been granted/refused ($).12.The extension of EEC type-approval with regard to the strength of the protection structures and the strength of their attachment to the tractor has been granted/refused ($).13.Place: 14.Date: 15.Signature: (; ) If applicable, state whether this is the first, etc. extension of the original EEC type-approval.

Notification concerning the granting, refusal, withdrawal or extension of EEC component type-approval with regard to the strength of a protection structure (rear-mounted rollbar, frame or cab) and to the strength of its attachment to the tractorEEC component type-approval No: extension (¹)1.Trade name or mark and type of protection structure: 2.Name and address of manufacturer of protection structure: 3.If applicable, name and address of authorized representative of manufacturer of protection structure: 4.Trade mark or name, type and commercial description of tractor for which protection structure is intended: 5.Extension of EEC component type-approval for tractors of the follow ...[+++]ing type(s) and, where appropriate, commercial descriptions: 5.1.The mass of the unballasted tractor, as defined in 1.4 of Annex II, exceeds/does not exceed (²) the reference mass used for the test by more than 5 %.5.2.The method of attachment and points of attachment are/are not (²) identical.5.3.All the components likely to serve as supports for the protection structure are/are not (²) identical.6.Submitted for EEC component type-approval on: 7.Test station: 8.Date and number of the report of the test station: 9.Date of granting/refusal/withdrawal of EEC component type-approval (²): 10.Date of granting/refusal/withdrawal of the extension of EEC component type-approval (²): 11.Place: 12.Date: 13.The following documents, bearing the component type-approval number shown above, are annexed to this certificate (e.g. report of the test station).

The sheet shall overlap solid parts of the container by at least 250 mm, measured from the centre of the securing rings, unless the system of construction of the container by itself prevents all access to the goods.