Traduction de «centrale de type en surface » (Français → Anglais) :

224. When a machine is tested in relation to a relevant local standard for either acceptance or in-service limits of error by measurement of a known area on a surface representative of the kind of material for which the machine is designed, the machine is within both the acceptance and in-service limits of error in respect of that area and that kind of material if the area registered does not differ from the known area by more than 0.006 square metres or 1.5 per cent of the kn ...[+++]own area, whichever is greater, and, in the case of a machine measuring in Canadian units of measurement, 1/16 square foot or 1.5 per cent of the known area, whichever is greater.

(a) it corrodes SAE 1020 steel or 7075-T6 non-clad aluminum surfaces at a rate exceeding 6.25 millimetres per year at a test temperature of 55°C when tested in accordance with Test Method, Laboratory Corrosion Testing of Metals for the Process Industries, NACE Standard TM-01-69 (1976 Revision);

‘use’ in relation to area means the use of area in terms of the type of crop as referred to in Article 44(4) of Regulation (EU) No 1307/2013, type of permanent grassland as defined in Article 4(1)(h) of that Regulation, permanent pasture referred to in Article 45(2)(a) of that Regulation or areas of grassland, other than permanent grassland or permanent pasture, or ground cover or the absence of a crop.

Where a Member State requires that the obligation to renovate each year 3 % of the total floor area extends to floor area owned and occupied by administrative departments at a level below central government, the 3 % rate shall be calculated on the total floor area of buildings with a total useful floor area over 500 m and, as of 9 July 2015, over 250 m owned and occupied by central government and by these administrative departments of the Member State concerned that, on 1 January of each year, do not meet the national minimum energy performance requirements set in application of Article 4 of Directive 2010/31/EU.

(i) For each surface water body type characterised in accordance with section 1.1, type-specific hydromorphological and physicochemical conditions shall be established representing the values of the hydromorphological and physicochemical quality elements specified in point 1.1 in Annex V for that surface water body type at high ecological status as defined in the relevant table in point 1.2 in Annex V. Type-specific biological reference conditions shall be established, representing the values of the biological quality elements specified in point 1.1 in A ...[+++]nnex V for that surface water body type at high ecological status as defined in the relevant table in section 1.2 in Annex V.

(i)For each surface water body type characterised in accordance with section 1.1, type-specific hydromorphological and physicochemical conditions shall be established representing the values of the hydromorphological and physicochemical quality elements specified in point 1.1 in Annex V for that surface water body type at high ecological status as defined in the relevant table in point 1.2 in Annex V. Type-specific biological reference conditions shall be established, representing the values of the biological quality elements specified in point 1.1 in An ...[+++]nex V for that surface water body type at high ecological status as defined in the relevant table in section 1.2 in Annex V.