Traduction de «procédures d’essai de puits » (Français → Anglais) :

27. Is concerned about the discrepancy of the CO2 emissions declared in official test results and those measured in real driving conditions; calls, therefore, for swift agreement on the WLTP correlation for fleet average CO2 targets, with due respect for the principle of ‘comparable stringency’ but without credit being given for unfair flexibilities in the current test procedure, in order not to weaken the 2021 target;

(i) drilling, (ii) well testing, (iii) logging and completion services, (iv) supply of specialised floating vessels.

Includes the following services rendered on a fee or contract basis: advisory and consulting services relating to mining, on-land site preparation, on-land rig installation, drilling, drilling bits services, casing and tubular services, mud engineering and supply, solids control, fishing and downhole special operations, wellsite geology and drilling control, core taking, well testing, wireline services, supply and operation of completion fluids (brines) supply and installation of completion devices, cementing (pressure pumping), stimulation services (fracturing, acidising and pressure pumping), workover and well repair services and plugg ...[+++]ing and abandoning of wells.

For vehicles not covered by standardised Community test procedures, comparability between different offers shall be ensured by using widely recognised test procedures, or the results of tests for the authority, or information supplied by the manufacturer.

(2) On the basis of actual in-service data to be supplied before 31 December 2003 by the Member States, the requirements of this section may be reviewed and consider (a) whether the definition of outlying emitter needs to be revised with respect to vehicles that have been type-approved according to the limit values given in row B of the table in section 5.3.1.4 of Annex I, (b) whether the procedure for identifying outlying emitters should be amended and (c) whether the procedures for in-service conformity testing should be replaced at an appropriate time by a new statistical procedure.

(12) Whereas new type-approval test cycles for gaseous and particulate emissions and smoke opacity are introduced that will allow a more representative evaluation of the emissions performance of diesel engines over test conditions that more closely resemble those encountered by vehicles in-service; whereas a new combined (two cycle) test procedure is introduced for conventional diesel engines and those diesel engines fitted with oxydation catalysts; whereas a new combined (two cycle) test procedure is introduced for gas-fuelled engines and, additionally, for diesel engines fitted with advanced emission control systems; whereas from 20 ...[+++]05, all diesel engines are to be tested on both applicable test cycles; whereas the Commission will monitor progress in negotiations towards a worldwide harmonised test procedure;