Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Automatic regulation of the contact-wire tension
Catenary wire tension
Contact line
Contact wire
Contact wire tension
Double-contact wire system
Line suspended by single catenary with 1 contact wire
Overhead trolley wire
Stagger of contact wire
Tension-regulated contact wire
Trolley wire
Twin

Traduction de «Contact wire tension » (Anglais → Français) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous
contact wire tension

tension mécanique du fil de contact


automatic regulation of the contact-wire tension

réglage automatique de la tension du fil de contact


tension-regulated contact wire

fil de contact régularisé


line suspended by single catenary with 1 contact wire | line suspended by single catenary with one contact wire

ligne à suspension caténaire simple à un fil de contact


trolley wire [ contact wire | overhead trolley wire ]

fil conducteur [ fil de contact | fil de trolley | fil de traction ]


contact line | contact wire

fil de contact | fil conducteur


catenary wire tension

tension mécanique du câble porteur




double-contact wire system | twin

ligne de contact double | jumeau
TRADUCTIONS EN CONTEXTE
Annex II A.With the wire ropes tensioned, the wedging beam shall be placed firmly behind the rear wheels and then fixed to the ground.1.2.3.If the tractor is of the articulated type, the point of articulation shall in addition be supported by a wooden block at least 100 mm square and firmly lashed to the ground.1.2.4.The pendulum block shall be pulled back so that the height of its centre of gravity above that at the point of impact is given by one of the following two formulae, to be chosen according to the reference mass of the tractors subjected to the tests:H = 25 + 0,07 mt for tractors with a reference mass of less than 2 000 kilogr ...[+++]

le bord supérieur. La position du centre de gravité du mouton se situe à un sixième de la largeur du sommet du dispositif de protection à l'intérieur d'un plan vertical parallèle au plan médian du tracteur touchant l'extrémité supérieure du sommet de dispositif de protection.Si le dispositif est courbe ou saillant en ce point, des coins doivent être ajoutés pour que le choc ait lieu en ce point, sans que cela se traduise par un renforcement du dispositif.1.2.2.Le tracteur doit être ancré au sol au moyen de quatre câbles, disposés chacun à une extrémité des deux essieux, conformément aux indications de la figure 6 de l'annexe IV. Les poi ...[+++]




datacenter (1): www.wordscope.fr (v4.0.br)

'Contact wire tension' ->

Date index: 2024-05-08
w