Traduction de «Assortiment des équipements » (Français → Anglais) :

Therefore, for each category of pressure equipment there should be an adequate procedure or a choice between different procedures of equivalent stringency.

screened by conventional x-ray equipment with hand searching of screened bags also being conducted on a continuous random basis, where the percentage of persons so searched is not less than 10 %, including those about which the operator has concerns; or

The recycling targets range from 50% to 80% depending on the type of equipment and recovery rates are also set for the different types of equipment.

A European benchmark on learning mobility accompanied by relevant indicators could help to encourage and monitor the progress of Member States towards the already agreed objective of increased mobility, as well as identify examples of good practice and support the development of peer learning initiatives.

1. Considers that the European Union strategy should be aimed at reaching a global agreement at international level (within the ICAO) on more stringent noise certification standards for aircraft, including a phase-out plan for the least noise-efficient aircraft within the current Chapter 3, including hushkitted aircraft and re-certificated aircraft with low by-pass ratios; this is also necessary if competition is not to be distorted in an increasingly globalised aviation market;

19. Whereas, in view of the nature of the hazards involved in the use of pressure equipment it is necessary to establish procedures for assessing compliance with the basic requirements of the Directives; whereas these procedures must be devised in the light of the level of danger which is inherent in the pressure equipment; whereas, therefore, for each category of pressure equipment there must be an adequate procedure or a choice between different procedures of equivalent stringency; whereas the procedures adopted are as required by Council Decision 93/465/EEC of 22 July 1993 concerning the modules for the various phases of the c ...[+++]onformity assessment procedures and the rules for the affixing and use of the CE conformity marking, which are intended to be used in the technical harmonization Directives (8); whereas the details added to these procedures are justified by the nature of the verification required for pressure equipment;